SKU
RFAPSM2-RAH-5

Miro 2-RAH-5 Rooftop Roller Pipe Support


•Optimally designed for a 2″ Pipe
•Maximum pipe OD (with insulation) is 2-1/2″
•Adjustable from the factory set height of 5″ down to a minimum height of 3-5/8″
•The maximum load is 140 lbs. (3.0 PSI.) Make certain each...
Read More
$20.55
 

A “roller-bearing” pipe support used to support roof-mounted gas pipes, electrical conduit, solar piping and other mechanical piping. Unique design absorbs thermal expansion and contraction of pipes thus preventing damage to the roof membrane. Pipes rest on a self-lubricating polycarbonate resin axle and roller.

  • Optimally designed for a 2″ Pipe
  • Maximum pipe OD (with insulation) is 2-1/2″.
  • Adjustable from the factory set height of 5″ down to a minimum height of 3-5/8″.
  • Maximum load is 140 lbs. (3.0 PSI.) Make certain each pipe support is properly elevated to evenly distribute weight at all pipe support locations.
  • Unit Weight: 1.35 LBS.
  • 12 per case, 17 lbs. per case. (Dimensional Weight 14 LBS)
  • Recommended spacing is not to exceed 10 feet centers depending upon the load.
  • 3/8″ All-Thread Type 304 Stainless Steel.
  • Axle, Roller, and Collar material: Polycarbonate.
  • All other metal parts are hot-dip galvanized.
Base Material Polycarbonate
Size The deck base is 10" x 7.5" and the maximum cradle width is 3", but is designed to hold a maximum of 2" outer diameter pipe.
Maximum Pipe Size 2" Outside Diameter
Maximum Pipe Clearance Maximum clearance height of 5"
Maximum Load Weight Maximum load weight may not exceed 140 lbs. (3.0 PSI) per pipe stand
Spacing The manufacturer's recommended spacing is not to exceed 10-foot centers depending upon the load.